User's Manual

3 • System Setup
WHITESTAR SIGNATURE™ System Rx Only – Z370147 Rev. C 1008 3-26
Wireless Remote
Control (Optional)
The wireless remote control keypad can be used to operate the WHITESTAR
SIGNATURE™ System. All Modes, Programs, Diagnostics and End Case can be
accessed and adjustments to the settings can be made with the remote control. The
buttons on the remote keypad work the same as the controls on the WHITESTAR
SIGNATURE™ System touch screen.
Figure 3.14 – Wireless Remote Control Module
When not in use, store the Wireless Remote Control on the top of the system to
charge the batteries.
After you turn the system On, press the Remote Control Backlight button to
activate the Remote Control. When the system is Off the Remote Control is in a
power save mode.
Note: After four to six minutes of idle time, the Remote Control goes into a power-
save mode. To turn the Remote Control on, press the Backlight button.
WARNING: DO NOT try to replace the Wireless Remote Control
batteries. Call your AMO Technical Service representative to replace the batteries.
1. Remote Backlight On 6. Mode Select
2. Reload 7. Mode Down
3. IV Pole Up 8. Navigation Up/Down
4. IV Pole Down 9. Navigation Left/Right
5. Mode Up 10. Select
!