User's Manual

4 • Equipment Operation
WHITESTAR SIGNATURE™ System Rx Only – Z370147 Rev. C 1008 4-12
Selecting and
Changing Mode
Parameters
The system's graphical user interface (GUI) and touch screen is designed for
ease-of-use, consistent application and maximum informational display during all
operating modes.
Your interface with the system requires only three basic steps, which apply to all of
the selections, settings and operations. Once this basic organization is understood,
you can move quickly and easily through all of the system functions and
operations.
The touch screen is organized into panels. The top panel shows current status,
configuration options, the bottle height, and the footpedal icon. The left-side
column lists the operating modes and submodes. The main panel that dominates the
screen shows current operating levels for aspiration, vacuum and power.
• To switch operating modes or submodes, press a button in the left panel. The
control panels in the main panel show the operating levels for that mode.
• To make basic changes to the settings, press the Up and Down arrows to increase
or decrease a value.
Note: Press on the number in the Settings control panel to open a numeric keypad
and enter the required value. Refer to Figure 3.17 Numeric Keypad Pop-up
Window. Press Enter to close the Keypad window.
• To change other control panel settings, such as Panel or Linear power, press the
Settings button on that control panel. A Settings window opens, and you can
make your selections.
Figure 4.10 – PHACO Mode Screen
• To make overall changes to a program, press Configuration on the top panel.