User's Manual

RX Only – NGP Z370500 Rev. B 1116
6-10
WHITESTAR SIGNATURE PRO System
6 • System Configuration
Remote Control Pairing
Note: Make sure that the back light feature for the wireless remote control is off
before you start the wireless setup process.
1. On the main screen, press Configuration.
2. On the Wireless Setup dialog box, press Remote Control.
3. Press Remote Pair.
Figure 6.9 – Wireless Remote Pair Screen
4. Follow the instructions shown on the screen.
5. Press the corresponding buttons on the wireless remote control as prompted.
6. Verify for each button that the corresponding button on the screen lights. If the
button does not light on the screen, the test fails. If the test fails contact AMO
for technical service. If remote pairing fails, follow the instructions on the
screen.
7. Press Exit to close the screen.
8. Press Exit to close the Configuration screen.
Wireless Remote
1. On the main screen, press Configuration.
Test
2.
Press Wireless Remote Test.
3.
Follow the instructions on the screen.
4.
Press Finished to close the dialog box.
5.
Press Exit to close the Configuration screen.