User's Manual

RX Only – NGP Z370500 Rev. B 1116
6-17
WHITESTAR SIGNATURE PRO System
6 • System Configuration
Set Units of Measure
for Vacuum
Follow these steps to set the units of measure for vacuum.
1. Press Configuration.
2. Press the Set Vacuum Units button.
Figure 6.16 – Set Vacuum Units Dialog Box
3. On the Set Vacuum Units dialog box, the current selection is highlighted in
green. Press the button for the units of measure you want to use for the display
of vacuum settings.
4. Press Finished to return to the Configuration screen
5. Press Exit to close the Configuration screen.