User's Manual

RX Only – NGP Z370500 Rev. B 1116
6-3
WHITESTAR SIGNATURE PRO System
6 • System Configuration
Testing the IV Pole Follow these steps to test the IV pole.
1. Press Configuration.
2. Press the IV Pole Test button.
Figure 6.2 – IV Pole Test
3. Press the Start button under Send to Top to move the IV pole to maximum
height.
4. Press the Start button under Send to 30 cm to move the IV pole to a height of
30 cm.
5. Press the Start button under Send to Bottom to move the IV pole to minimum
height.
6. Press Finished to close the IV Pole Test dialog box and return to the
Configuration screen.
7. Press Exit to close the Configuration screen.