11.0

5. If you want the site to be available via https only, then choose it in the tree of sites, open SSL Settings and

select the option “Require SSL.”

Note: Verification of client certificates is not performed, so when configuring SSL, set the value of the “Client certifi-

cates” option to Ignore.

Once the certificated is connected, the “https” protocol must be written in the address of the Application Server and

the computer name must match the name for which the certificate is issued: https://<server name>.

This is required in the following cases:

1) When specifying the address of the Application Server on the Processing Server. To specify the address, do the

following:

- start the Processing Server Monitor;

- in the Processing Server local menu, select the “Change Application Server” item;

- in the dialog that opens, specify the address: https://<server name>.

2) When working on user stations, the server address https://<server name> must be specified when you start the

station or open a project

3) Similarly, when working on Web stations, the station URL must be entered starting from the server address:

https://<server name>/FlexiCapture11/<Web station name>

Recommendations for setting up ABBYY FlexiCapture

General recommendation

To improve performance of ABBYY FlexiCapture, use the following recommendations:

- Install SQL Server and FlexiCapture Application Server on different computers. The Processing and Licensing serv-

ers can be installed on the computer where the Application Server is installed.

- Do not install processing stations on the computes where FlexiCapture servers or SQL Server are installed.

- Do not store all data in SQL database. For these purposes, a File Storage should be used. This option must be se-

lected when creating a database in the Administration and Monitoring Console. If a file storage was not created when

creating a database, it cannot be connected later while working. During work, it is also impossible to disconnect the

file storage which was connected when creating the database.

These recommendations are described in more detail below.

Configuring SQL Server

RAM

The amount of RAM available to SQL Server should be not less than the amount recommended by Microsoft for the

given edition of MS SQL Server (see the table of recommendations for different editions).

The more RAM is available, the larger part of database can fit in RAM which allows faster access to database.

However, if FlexiCapture servers are installed on the same computer, the amount of RAM available to SQL Server

must be restricted in SQL Server settings so that the amount of RAM was also sufficient for FlexiCapture servers in-

cluding IIS (recommended amount of RAM is at least 4 GB). Thus, in order to improve performance, it is recommend-

ed that SQL Server and FlexiCapture Servers should be installed on different computers.

Hard disk