11.0

Values of the counters are recorded by the Processing Server, so the counters are available in the computer where

this server is installed.

As the Processing Server is a 32-bit application, the Performance Monitor utility must be run in 32-bit mode when

used in 64-bit computers. For this, enter the following command in the command line (cmd.exe):

mmc /32 perfmon.msc

By default, recording counters by the Processing Server is disabled. To enable counters recording, do the following:

1. Start the Processing Server console. For this, on the computer where the service of the Processing Server is

started, execute the following command in the command line (cmd.exe):

FlexiBRSvc.exe please obey

2. Set the value of the server parameter PerformanceCounting to true. For this, execute the command:

set PerformanceCounting=true

3. Check the state of the PerformanceCounting parameter with the “view” command.

4. Quit the Processing Server Manager console using the “quit” command.

Note: To view help on the Processing Server Manager console, use the “help” command.