User's Guide

Abeeway Tracker Reference Guide FW 2.1 V1.1
Page 16 of 23 10
th
November 2020
Restricted distribution
Sequence Action Output
One short press
Battery level is shown with
the LEDs
LED pattern
(See next section)
Three short presses
Trigger an alert position or
start/ end the SOS mode
LED pattern
(see next section)
https://youtu.be/HgsMfytTue4 (SoS)
https://youtu.be/7BAg7XF2jyk (Alert)
Double short press
Add a tracker in the
whitelist contact
(proximity feature)
(4)
Any press when battery low
(short or long press)
(1)
Go to OFF mode, except if
mode disabled
Buzzer melody
fast LED blinking
One long press when device OFF and
good battery
Switch ON the tracker
LED pattern
(See next section)
https://youtu.be/T9dfVbptpsM
One long press when device ON.
Go to the OFF mode,
except if mode disabled or
if the tracker is in SOS
mode
Buzzer melody
https://youtu.be/gNtn3KRglrU
While the button is pressed when the
device is ON
Blue LED ON
https://youtu.be/0b3yLGs_4Gw
4 short press, 1 long press, 1 short
press, 2 long press
(2)[3]
Enters in BLE bootloader
BLE firmware can be updated.
https://youtu.be/XILHAbWMKZs (Part 1)
https://youtu.be/QG58rI-mQwM (Part 2)
4 short press, 1 long press, 2 short
press, 1 long press until the end of
the melody
(2)[3]
Enters in MCU bootloader
MCU firmware can be updated
https://youtu.be/etZ0FA_ssso
4.11.2 LED interface
The end user can observe the behavior of tracker via the LED interface. Several patterns have been defined for
different outputs.
LED blinking patterns
Action Status Pattern LED Color
Device switched on Fade in effect Blue
Device switched off Fade out effect Red
Battery check
with button
the battery level is >75% 3 long blinks Blue
the battery level is between 50% and 75% 2 long blinks Blue
the battery level is between 25% and 50% 1 long blink Blue
the battery level is <25% 1 long blink Red
Low battery detected: Go to the OFF mode 3 short blinks Red
LoRaWAN
TM
join operation failed 6 short blinks Red
Device starting for the first time after the join success Three long blinks Blue
SOS mode. Blinking remains until the mode is left
(1)
Permanent long blinks Red
Device acknowledges the alert position request
(1)
8 short blinks Red
GPS fix done
(1)
(2 short blinks, one long blink) x 3 times Blue
Device is reset short blinks Pink