User's Manual

AVS-121

Jan, 2011

TROUBLE SHOOTING

Q1: Got No Picture or Sound After The Setup ?

--> Check the power adapters and see if the power LED on both TX and RX units

are on. If not, check the connection of power adapters and make sure that the

power on/ff switch in the back of TX and RX units are switched on correctly.

--> Check if all the A/V cables are known good and connected well.

--> The ID code dip switch settings from both transmitter and receiver units must

be matched in the same configuration.

--> Check if the Transmitter and Receiver are set at using the same channel

frequency.

2. Got Interference Experienced In The Image/Sound ?

--> Move your transmitter or receiver unit slowly to find a better reception position

for your A/V system.

--> Try to have the transmitter get closer to the receiver unit.

--> Move the TX and RX units away from possible interference from microwave

oven or cordless phone.

--> Try switching the channel frequency to avoid interference.

--> Check if the Transmitter and Receiver are set at using the same channel.

3. Remote Control Function Does Not Work ?

--> Check the batteries in your device’s remote controller first.

-->Make sure the IR remote extender wire is facing toward the A/V device’s IR

window and the remote controller is aiming toward the IR sensor window located

on the front panel of the Receiver unit.

-->Make sure the distances from your remote control to the receiver’s IR window

and from remote extender wire to the transmitter are within the valid range.

-->Check the ID code setting on both TX and RX units are the same one.