User's Manual

AVS-121
9
Jan, 2011
4. What The ID Code Setting Is Used For ?
This ID code setting helps users avoid the possible interference of remote
controller originated from your neighborhood. For example both you and the
neighbor have the same satellite receiver model with same remote and IR codes
programmed. In this coincidence your neighbors remote controller may interfere
with your receiver when both of you are also using our same wireless A/V
transmitter kit for remote control extension. That is why we design this ID code
switch for users to avoid such an interference on the remote control when the
unlikely does happen.
--> Make sure that both ID codes of transmitter and receiver are set the same
positions. In most cases, you do not need to worry about this ID code setting.
Default setting is recommended.
-->The ID code can be configured in 8 different types through using the dip switch
on the back panel of transmitter TX unit or receiver RX unit. Again in most cases,
you do not need to worry about this ID code setting. Default setting is always
recommended unless change is necessary.