User's Manual

Table Of Contents

OPERATIONOPERATION

Work with TV

Step 1:

Power on the receiver and camera

Step 2:

Complete the pairing

Step 3:

Receiver connects to TV by RCA or Scart cable (P7)

Step 4:

Press the TV/AV button on controller of TV, then switch to camera channel.

You can select any setting on receiver when the TV monitor is switched to camera.

Step 5:

Press the hot key on receiver to stop the buzzer after detonating.

(The buzzer function will start to work again after 2 minutes. )

Work with Computer

Install the software to computer (P8)

Step 2:

Power on the receiver and connect to computer by USB cable(P7)

Step 3:

Power on the camera

Step 4:

Open the A+ alarm

Step 5:

Then start to work(P8)

Step 6:

The buzzer on receiver and computer are both alarm.

(The buzzer function on receiver side will start to work again after 2 minutes. )

And press the buzzer off on software to stop the buzzer after detonating.

Step 1:

Notice:

Please refer to the trouble shooting when the A+ alarm software is showed

“ Can not connect to device” .