@ EET EZEKIEL] Please note that the Filigree HEAP 51/82/53 should only be used with parts approved by Abe storm. The use of unauthorized parts or alterations to the machine could void your warranty. Contact an approved distributor for further assistance. To Avoid the Risk of Fire or Electric Shock: + Unit must be electrically grounded. « Insert 3-prong plug directly into outlet with Ground Fault Circuit Interrupting device. « Do not use an adapter with this unit. + Do not use the unit in standing water.
= REBEKAH Removable Intake Panel The Filtrate HEAP $1/82/S3 is equipped with a removable panel on the intake side of the machine. The removable panel is quite useful in remediation applications, so you can draw air out the room and create more negative pressure (use a manometer to monitor air pressure). To use panel: 1. Remove the panel. 2. Install the machine outside the containment area to draw air out. 3. Cut a hole in the containment plastic that is the size of the unit's inlet. 4.
Filtrate HEAP S3 Handle at p— Latches(4 total) Removable foam cap {with cap leash} — Control Panel . Inlet {duct able, 16") Winding Clamp {4 total) Hh Latches(d total) — Jy Outlet 2 Vertical, {(duct able, 87) upright position Retaining Clips (4 on base) ill SETUP 1. Place the firewater HEAP $1/52/83 so that iris in the upright, vertical position. 2. Plug the machine into a standard 115 volt outlet. Note: Each unit needs 3 amps to operate. 3.
= FEST OR #l THE CONTROL PANEL Variable Speed Control The Variable Speed Control is used to adjust the power of the machine. Turn the knob in a clockwise direction, to increase the speed from maximum to minimum. The minimum speed setting is located immediately under the OFF button. Auxiliary Outlet If more air filtration is necessary for a space, you can“daisy chain" or link up to 3 Filtrate HEAP S1/52/S3's to the same outlet.
* Always wear approved protective gear when changing the filters. * Filters should be changed after each remediation job. « If the indicator light is on, always change the Cultivated Carbon Filter. Water Damage In this application, the Filtrate HEAP 51/52/83 should be placed in the center of the affected area. The air scrubber will draw in the air, filter it, then blow out the newly cleaned air. To begin the process, simply turn on the scrubber and it will start cleaning the air.
« Always unplug the unit prior to performing any maintenance. Check the power cord for damage (fraying, cuts, etc.) before use. Verify that the GF CI outlet is working by powering on the machine and pressing the red Clog test button. If the outlet is working, the“reset” button will pop up. To operate, press the reset button again. To avoid electric shock, never use a water hose or pressure washer to clean the electrical components.
LIMITED WARRANTY EX SINS This limited warranty covers manufacturing defects in materials or workmanship encountered in a normal household, commercial or noncommercial use of this product and shall not cover the following: + Damage occurs in uses for which this product was not intended for. + Damage caused by unauthorized modification or alteration of the product. + Cosmetic damage including scratches, dents, chips, and other damage to the product's finishes.
1 ENTER ORM i Wiring Diagram CAPACITANCE Black TIMER UV TUBE Black CIRCUIT BREAKER CHANGE FILTERER White L] Heh Wind pressure switch
