Installation Guide

NOTE: paper and cardboard templates where
supplied are only to be used as a guide.
Using the actual sink ensures a more
accurate cutout.
Clean the boom of the countertop and the
top flange (or lip) of the sink with methylated
spirits. Then apply a bead of silicone to the
top edge of the bowl.
Posion sink in place then install the bridge
plates and ghten the nylon nuts. Note each
clip is designed to support >30kg, when used
with stone or stonelike benchtop.
Plates & bolts should be posioned 10mm
from the sink edge.
Use a stone adhesive, to aach bolts to the
underside of the benchtop.
Allow sufficient me for adhesive to cure.
Templates are supplied only as a guide. The physical use of the sink will ensure a more accurate cutout. Abey recommends that undermount sinks and routering of your solid
surface material should be installed by a professional installer for best results. Warranty is voided if epoxy or adhesive is used to secure the sink to the bench.
STAINLESS STEEL UNDERMOUNT SINK
INSTALLATION INSTRUCTIONS
1
SILICONE
SEALANT
32
Stone
Adhesive
Plate
& Bolt
Plate
& Bolt
Nylon
Nut
BENCH