User Guide

LE910Cx HW User Guide
1VV0301298 Rev. 34 Page 113 of 131
Not Subject to NDA
product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed. The end product with an embedded module may also need to pass the FCC Part
15 unintentional emission testing requirements and be properly authorized per FCC Part
15
Trace antenna designs
See 7.2 GSM/WCDMA/TD-SCDMA/LTE Antenna - PCB Line Guidelines
Summary of the specific operational use conditions
See apart 7.1 GSM/WCDMA/TD-SCDMA/LTE Antenna - Antenna requirements
Modification Statement
Telit has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment.
Telit n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en
soit la nature. Tout changement ou modification peuvent annuler le droit d’utilisation de
l’appareil par l’utilisateur.
Interference Statement (if it is not placed in the device)
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Wireless Notice
This device complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines
and RSS‐102 of the ISED radio frequency (RF) Exposure rules. Antenna gain must be
below: