User Guide
Table Of Contents
- APPLICABILITY TABLE
- Contents
- 1. Introduction
- 2. general Product Description
- 3. Module Connections
- 4. Electrical Specifications
- 5. Hardware Commands
- 6. Power Supply
- 1.
- 7. Antenna(s)
- 8. Hardware Interfaces
- 9. Miscellaneous Functions
- 1.
- 1.
- 1.
- 1.
- 1.
- 10. Mounting the Module on your Board
- 11. Application Guide
- 12. Packing System
- 13. Conformity Assessment Issues
- 1.
- 1.
- 1.
- 14. PRODUCT AND SAFETY INFORMATION
- 15. GLOSSARY
- 16. Document History
LE910Cx HW User Guide
1VV0301298 Rev. 34 Page 74 of 131
Not Subject to NDA
Figure 17: RS232 Level Adaption Circuitry Example
Note: In this case, the length of the lines on the application must be
taken into account to avoid problems in the case of high-speed rates
on RS232.
The RS232 serial port lines are usually connected to a DB9 connector as shown in Figure
18. Signal names and directions are named and defined from the DTE point of view.
Figure 18: RS232 Serial Port Lines Connection Layout
Peripheral Ports
In addition to the LE910Cx serial ports, the LE910Cx supports the following peripheral
ports:
• SPI – Serial Peripheral Interface
• I2C - Inter-integrated circuit
• SD/MMC Card Interface
• SDIO Interface
8.5.1. SPI – Serial Peripheral Interface
The LE910Cx SPI supports the following:
• Master Mode only