User Guide
Table Of Contents
- APPLICABILITY TABLE
- Contents
- 1. Introduction
- 2. general Product Description
- 3. Module Connections
- 4. Electrical Specifications
- 5. Hardware Commands
- 6. Power Supply
- 1.
- 7. Antenna(s)
- 8. Hardware Interfaces
- 9. Miscellaneous Functions
- 1.
- 1.
- 1.
- 1.
- 1.
- 10. Mounting the Module on your Board
- 11. Application Guide
- 12. Packing System
- 13. Conformity Assessment Issues
- 1.
- 1.
- 1.
- 14. PRODUCT AND SAFETY INFORMATION
- 15. GLOSSARY
- 16. Document History
LE910Cx HW User Guide
1VV0301298 Rev. 34 Page 88 of 131
Not Subject to NDA
9. MISCELLANEOUS FUNCTIONS
Indication of Network Service Availability
The STAT_LED pin status shows information on the network service availability and call
status. In the LE910Cx module, the STAT_LED usually needs an external transistor to
drive an external LED.
The STAT_LED does not have a dedicated pin. The STAT_LED functionality is available on
GPIO_01 pin (by default GPIO_01 functions as STAT_LED)
See the AT Command User Guide for details about the AT#SLED section.
LED Status
Device Status
Permanently off Device off
Blinking
Blinking 1s on and 2s off Registered in idle
Blinking time depends on network
condition in order to minimize
power consumption
Registered in idle with power saving
Permanently on Not registered
Table 39: Network Service Availability Indication
Figure 25: Status LED Circuit Example