User Guide

3-14 Chapter 3
IR Duplex Mode IR duplex mode Half(Default) or Full selection.
Onboard Parallel Choose Disable, 3BCh/IRQ7, 278h/IRQ5, or 378h/IRQ7
Port (Default) to set the on-board parallel port.
Parallel Port Choose EPP1.7, EPP1.9, ECP, ECP + EPP1.7, ECP +
Mode EPP1.9, PS/2, or Normal (Default) mode.
ECP Mode Use Choose DMA channel 1 or channel 3 to set the ECP
DMA mode.
Onboard IDE This option enables or disables the one board PCI IDE
Controller controller.
Onboard IDE PIO Choose Mode 0 ~ Mode 4, or Auto (Default) to change
Mode IDE data transfers speed.
Load BIOS Defaults
BIOS Defaults indicates the values required by the system for the minimum
performance. Choose this item and following message appears:
“Load BIOS Defaults (Y/N)? N”
To use the BIOS defaults, change the prompt to “Y” and press <Enter>.
Load Setup Defaults
Setup Defaults indicates the values of system parameters which will give the
best performance. Choose this item and the following message appears:
“Load Setup Defaults (Y/N)? N”
To use the Setup defaults, change the prompt to “Y” and press <Enter>.