Specifications

2-262-26
2-262-26
2-26
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
Onboard LAN [Enabled]Onboard LAN [Enabled]
Onboard LAN [Enabled]Onboard LAN [Enabled]
Onboard LAN [Enabled]
Allows you to enable or disable the onboard LAN controller. Keep the
default [Enabled] if you wish to use the onboard LAN feature. Set to
[Disabled] if you installed a PCI LAN card. Configuration options: [Disabled]
[Enabled]
Onboard LAN Boot ROM [Disabled]Onboard LAN Boot ROM [Disabled]
Onboard LAN Boot ROM [Disabled]Onboard LAN Boot ROM [Disabled]
Onboard LAN Boot ROM [Disabled]
Setting to [Enabled] allowed the BIOS to invoke the boot ROM of the
onboard LAN chip. Configuration options: [Enabled] [Disabled]
AC97 Audio [Enabled]AC97 Audio [Enabled]
AC97 Audio [Enabled]AC97 Audio [Enabled]
AC97 Audio [Enabled]
Allows you to enable or disable the onboard AC`97 Audio controller.
Configuration options: [Disabled] [Enabled]
PCI IEEE 1394a [Enabled]PCI IEEE 1394a [Enabled]
PCI IEEE 1394a [Enabled]PCI IEEE 1394a [Enabled]
PCI IEEE 1394a [Enabled]
Allows you to enable or disable the onboard IEEE 1394a device support.
Configuration options: [Disabled] [Enabled]
Serial Port1 Address [3F8/IRQ4]Serial Port1 Address [3F8/IRQ4]
Serial Port1 Address [3F8/IRQ4]Serial Port1 Address [3F8/IRQ4]
Serial Port1 Address [3F8/IRQ4]
Allows you to set the addresses for the onboard serial port connector.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4]
[2E8/IRQ3]
Parallel Port Address [378/IRQ7]Parallel Port Address [378/IRQ7]
Parallel Port Address [378/IRQ7]Parallel Port Address [378/IRQ7]
Parallel Port Address [378/IRQ7]
Allows you to set the base address of the onboard parallel port connector.
If you disable this field, the Parallel Port Mode and ECP DMA Select
configurations are not available. Configuration options: [Disabled]
[378/IRQ7] [278/IRQ5] [3BC/IRQ7]
Parallel Port Mode [ECP+EPP]Parallel Port Mode [ECP+EPP]
Parallel Port Mode [ECP+EPP]Parallel Port Mode [ECP+EPP]
Parallel Port Mode [ECP+EPP]
Allows you to set the operation mode of the parallel port.
Configuration options: [SPP] [EPP] [ECP] [ECP+EPP]
ECP Mode Use DMA [3]ECP Mode Use DMA [3]
ECP Mode Use DMA [3]ECP Mode Use DMA [3]
ECP Mode Use DMA [3]
Allows you to select the ECP Mode. This item becomes configurable only if
the
Parallel Port ModeParallel Port Mode
Parallel Port ModeParallel Port Mode
Parallel Port Mode is set to [ECP] or [ECP+EPP]. Configuration
options: [1] [3]