User`s manual

2-2 Chapter 2
2.2. Installing the System Board
Before installing the system board, exam your chassis to ensure this system board fits
into it.
1. Face the side of the I/O ports toward the rear part of the chassis.
2. Locate the screw holes on the system board and the chassis base.
3. Place all the studs or spacers needed on the chassis base and have them tightened.
4. Line up all the screw holes on the board with those studs or spacers on the chassis.
5. Tightens all the screw holes.
ATTENTION: To prevent shorting the PCB circuit, please REMOVE the metal studs
or spacers if they are already secured on the chassis base and are without
mounting-holes on the system board to align with.
IS-10 / IS-11 / IS-12