User's Guide

KH667111xx
© ABITRON Control Systems GmbH
Coder CMB-1
09.02.2021 / FRM
Seite
page
9
5.7 RF exposure considerations
WARNING:
In order to comply with the FCC RF Exposure limits, the end customer has to assure that the antenna of the
device has a distance of more than 8mm from the human body for bodyworn devices.
For handheld devices, no distance is needed.
In order to comply with the ISED RF Exposure limits, the end customer has to assure that the antenna of the
device has a distance of more than 15mm from the human body for bodyworn devices.
For handheld devices, no distance is needed.
Nevertheless, this device should be used in such a manner that the potential for human contact during normal
operation is minimized. However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital device emissions,
PC peripheral requirements, etc.).
5.8 Antennas
5.8.1 902-928MHz
A ABITRON Dipole-Antenna “DiPol_STP-868” is intended for 902-928MHz
Frequency range:
Impendance:
VSWR:
Peak Gain:
863-928MHz
50Ω
<2:1
2.9 dBi
5.8.2 2.4GHz
A ABITRON Dipole-Antenna “DiPol_STP-2G4” is intended for 2.4GHz
Frequency range:
Impendance:
VSWR:
Peak Gain:
2 400 MHz
50Ω
<2:1
4.3 dBi
5.9 Label and compliance information
The CMB-1 module is labelled with its own FCC/IC ID. If the FCC/IC ID is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed must also
display a physical label or eLabel referring to the enclosed module. In that case the end product must be
labelled in a visible area with the following:
contains
FCC ID: 2AC8P-CMB1
IC ID: 12310A-CMB1