User's Guide

5 Integration Instructions
for host product manufacturers according to KDB 996369 D03 OEM Manual v01
5.1 List of applicable FCC & RSS rules
Part 15.247
RSS-247
5.2 Specific operational use conditions
This module is approved for use in portable and mobile applications. Integrators must supply operating
instructions for end users and installers to satisfy RF exposure compliance requirements are met. Integrators
and installers must also make sure that compliance with Part 15B are ensured.
5.3 Limited module procedures
N/A, a full modular approval is targeted.
This module is compliant with Chapter (b) from §15.212.
5.4 Trace antenna designs
N/A, the module does not use a trace antenna, it uses an external dipole antenna
5.5 Antenna assembly
One of the under point 0 mentioned antennas has to be used.
Take care that there enough distance from the antenna to metal parts, which are not used as part of the
antenna (e.g. ground plane).
As a guidance λ/10 can be used:
• ~3,3cm @915MHz
• ~1,2cm @2,4GHz
Use a suitable antenna socket (TNC/RP-TNC) for the interface between MBT-1 and selected antenna.
e.g.:
5.6 Integration Tests
For integration tests in your device, please use following setting files:
902-928MHz:
rfEasyLinkTx_14dbm_902200_modulated.out
2.4GHz:
rfEasyLinkTx_6dbm_2402000_modulated
Please ask your contact partner for these setting files.
5.7 RF exposure considerations
WARNING:
In order to comply with the FCC RF Exposure limits, the end customer has to assure that the antenna of the
device has a distance of more than 8mm from the human body for bodyworn devices.
For handheld devices, no distance is needed.
In order to comply with the ISED RF Exposure limits, the end customer has to assure that the antenna of the
device has a distance of more than 15mm from the human body for bodyworn devices.
For handheld devices, no distance is needed.
Nevertheless, this device should be used in such a manner that the potential for human contact during normal
operation is minimized. However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital device emissions,
PC peripheral requirements, etc.).