User's Manual

1-11
Siemens 9751 9006i DTMF Integration Guide
OL-1747-02
Chapter 1 Siemens 9751 9006i DTMF Integration
Configuring Cisco Unity for the Integration
Step 4 If the setting is not Analog or Multiple Integrations, contact your sales
representative for the necessary system key.
Step 5 Go to System > Switch. Confirm that the settings match those in Table 1-9. If the
settings are incorrect, integration features may not be enabled.
Step 6 If necessary, edit the codes that turn message waiting indication on and off. The
MWI codes are located in the Active Switch Setting area at the top of the Switch
Settings page.
Step 7 Click the Save icon.
To enter port settings
Step 1 In the Cisco Unity Administrator, go to System > Ports.
Step 2 Select a port in the table.
Step 3 Indicate the settings for the port.
If you are setting up a hunt group, use the first voice-messaging ports for
incoming calls and the last ports to dial out. This helps minimize the possibility
of a collision, in which an incoming call arrives on a port at the same time that
Cisco Unity takes the port off-hook to dial out.
Step 4 Type the extension for the port.
Step 5 Repeat Steps 2 through 4 for the remaining ports.
Step 6 Click the Save icon.
Table 1-9 Switch Settings
Switch Parameter Required Setting
Manufacturer Siemens
Model Hicom 300E
Switch PBX Software Version All
Integration Analog