User guide

If you receive a failure notiﬁ cation, please refer to the

“Troubleshooting Guide” on page 37 of this manual to

determine the cause.

This testing feature is very useful - allowing you to con-

ﬁ rm that the system has coverage from all parts of your

home. Simply walk to the various parts of your home and

push the Battery Check / System Check button until you

hear the 4 beeps and then the dial tone. You can then

release the button, and you will hear the voice prompt

“All Systems are OK”, “Pendant and Base out of Range”,

or “System Cannot Detect Dial Tone”.

NOTE: If your telephone service offers voice mail and

the voice mail system uses a Stutter Dial Tone to notify

you of a message, the system test may fail – “cannot

detect dial tone” if a system test is made with a message

waiting. This is normal as the System is “listening” for

a conventional dial tone. Check your messages so the

dial tone returns to a solid tone and test again. In the

event of an emergency, the System will dial the emergen-

cy number regardless of a standard or stutter dial tone.

Caution - To ensure proper operation, this equipment

must be installed according to the these instructions.

We highly recommend that you perform this System

Check after set-up and installation and at least twice a

month to conﬁ rm that your system is working properly

and that the pendant and base unit are in good commu-

nication and that the base unit can get a dial tone. It is

also recommended to perform this system check after a

lightning storm that could damage the base unit which is

plugged into the phone line.