Reference Manual

CHAPTER 14. RECORDING NEW CLIPS 184
14.3.3 Overdub Recording MIDI Patterns
Live makes pattern-oriented recording of drums and the like quite easy. Using Live's Impulse
instrument and the following technique, you can successively build up drum patterns while
listening to the result. Or, using an instrument such as Simpler, which allows for chromatic
playing, you can build up melodies or harmonies, note by note.
1. Set the Global Quantization chooser to one bar.
2. To automatically quantize the notes you are about to record, choose an appro-
priate value for Record Quantization.
3. Double-click any of the Session View slots in the desired MIDI track (the one
containing the Impulse or other instrument). A new, empty clip will appear in the
slot. The new clip will default to a loop length of one bar, but you can change
that by double-clicking the clip and changing its loop properties.
4. Arm the track.
5. Launch the clip.
6. The notes you play are added into the looping clip, and you can observe your
recording in the Clip View.
7. By default, the Control Bar's Overdub switch is activated, so that you can build
your pattern layer by layer. However, if you would like to pause recording for a
moment to rehearse, you can deactivate the Overdub switch. The contents of
the clip will continue to play, but you can play along without being recorded.
When you are ready to record again, simply turn on the Overdub switch.
8. Stop recording by pressing a Clip Stop button or the Stop button in the Control
Bar.
Note that holding
Alt
(PC) /
Alt
(Mac) while double-clicking the empty slot to create
a new clip will implicitly arm the track and launch the clip.
At any time while overdub recording is going on, you can use the Undo command to remove
the last take, or even draw, move or delete notes in the Clip View's Note Editor.
Note that you can also add notes to existing Session clips while the Overdub switch is on.