Reference Manual
CHAPTER 22. LIVE INSTRUMENT REFERENCE 368
LFO Retrigger (Retrig) Enabling Retrigger for an LFO will cause it to reset to its starting
point, or initial phase, on each new MIDI note. This can create hybrid LFO shapes if the LFO
is retriggered before completing a cycle.
LFO Offset (Offset) This changes the starting point, or initial phase of an LFO, so that
it begins at a different point in its cycle. This can create hybrid LFO shapes if the LFO is
retriggered before completing a cycle.
LFO Rate < Key (Key) Also known as keyboard tracking, non-zero values cause an LFO's
rate to increase relative to the pitch of incoming MIDI notes.
LFO Stereo Mode (Stereo) LFOs 2 and 3 can produce two types of stereo modulation:
Phase or Spin. In phase mode, the right and left LFO channels run at equal speed, and the
Phase parameter is used to offset the right channel from the left. In spin mode, the Spin
parameter can make the right LFO channel run up to 50% faster than the left.
22.8.8 The MIDI Tab
The MIDI Tab.
The MIDI tab's parameters turn Sampler into a dynamic performance instrument. The
MIDI controllers Key, Velocity, Release Velocity, Channel Pressure, Modulation Wheel, Foot
Controller and Pitch Bend can be mapped to two destinations each, with varying degrees
of inuence.