Reference Manual

519 Using Push
Repeat — when Repeat is enabled, holding down a pad will retrigger the note. The Scene/Grid
buttons change the rhythmic value of the repeated note.
Accent — when Accent is enabled, all incoming notes are played at full velocity. Hold Accent
and press a step sequencer step to program the step at full velocity.
Octave Up/Down — if an instrument track is selected, these buttons shift the pads up or down
by octave. If a Drum Rack is selected, these buttons shift the Drum Rack’s pad overview up or
down by 16 pads. In Session Mode, these buttons shift control of the Session View up or down
by eight scenes. These buttons will be unlit if no additional octaves are available.
State Control Section
State Control Section.
When working with tracks, the leftmost eight buttons will either stop clips or mute or solo the cor-
responding track, depending on which of the three rightmost buttons is pressed (Stop, Mute, or
Solo). When working with devices instead of tracks, the leftmost eight buttons will toggle devices
on and off. These buttons have additional functionality in other modes (scale selection, etc.)
Tip: to stop all clips, press and hold Shift, and then press Stop.
Selection Control Section
Selection Control Section.
These buttons work in conjunction with the Display/Encoder Section buttons and select what
parameters can be edited by the encoders and shown in the display. The In and Out buttons
allow you to access devices inside Racks or additional parameter banks for devices with more
than eight parameters.