User Manual

- 13 -
3.2. Data Synchronization
To share information between your Wireless Thin Client and your
PC/Laptop, you need to establish a direct PC Connection. There are
two ways to make direct connection.
A. Active sync via USB port of the Cradle Station.
Step 1. Cable Connection:
Go to
Start→Settings→ Control Panel→PC Connection, click
“Change …” bottom, select “connect to desktop computer using”
to “USB Sync” and press “OK”.
i. Plug the USB Type B Connector of USB cable to the USB
Type B Port at the rear side of the cradle.
ii. Plug the USB Type A Connector of USB cable to the USB
Type A Port in your PC/Laptop.
Step 2. PC Setup:
Prerequisite: To make the connection, you will need to install the
ActiveSync 3.71 (or higher) software to your PC/Laptop. To
download this freeware, go to:
http://www.microsoft.com/downloads
to search and download “ActiveSync” to install.
On your PC/Laptop
i. Make sure Microsoft ActiveSync is well installed in your
PC/Laptop.
ii. Open Microsoft ActiveSync.
iii. Select File Get Connected. Both your PC/Laptop and the
Tablet will detect the connection and launch the counterpart
software to make the connection.