FCC COMPLIANCE STATEMENTS FCC Part 15 Registration This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Part 68 Registration This equipment complies with Part 6% of the FCC Rules. On the bottom of this equipment is Label that contains, among other information. the FCC registration Number and Ringer equipment Number (REN) for the equipment. [ requested, this information must be given to the Telephone Company The REN is useful to determine the quantity of devises you may comic! to your telephone line and still have all of those devices ring when your telephone number is called. In most.
INTRODUCTION The HB200. HCA2000, and HL2000 are Home Net to Ethernet Bridge. HB2000 serve as a bridge between the well-known Ethernet segment and current home network (hereafter refer as Home Net) . 1t filters the error packets and switches good packets between these two networks. HCA2000 or HL200G is not only a bridge but also a NAT router build-in a CPD server. It serves as an IP (Internet Protocol} sharing device.
HARDWARE INSTALLATION Parts Names and Functions LED Indicators on the Front Panel Ports on the Rear Panel QO ® © LED Active Color Status Indicator Glowing Dimming Flashing OD [Power Green DC Sv power|Not powered N/A feeding in (@ {Home Net Green N/A Disconnected from connected fo a A [Actuality Homepage device Homepage device Gs (reserved) N/A N/A N/A N/A. @ (reserved) N/A N/A N/A N/A.
Part Name Type | Functions Connects the power adapter plug. B {Console DR-9 [Connects a RS-232 serial cable to your computer for female [firmware upgrade. C [Ethernet RI-45 [Connects to a Theme device.
Hardware Connections 1. Select a convenient location for the Home Net Bridge near the PC or Ethernet device to which it will be connected 2, Using a standard telephone line to connect Home Net port with Homepage device. 3. Using a UTP CATS {a cross-over cable may be used if the linked port is MID-II port } connect to a basset {or compatible) deviate, 4. Connect the Power Adapter to feed the power.
FIRMWARE UPGRADE System Requirements «One free COM port on PC. «A pin-to-pin RS-232 cable. One end is 9 pin male connector, the other end pin female connector depends on the COM port. » PWLOAD.EXE : This is a DOS program for firmware upload. You can run it directly from Windows NT/95 also. «© HBIKFW.BIN: This is a firmware image file. This file MUST reside in the same sub directory with FWLOAD.EXE.
SPECIFICATIONS Standards » JKEES02.