User's Manual

8 -
Installing Ethernet Cabling
1. Connect the UTP Ethernet cable to the
RJ-45 port of the USB 1M HomePNA &
10/100 Fast Ethernet.
2. Plug the other end of the cable into a
10BaseT or 10/100 switching hub
2
.
Installing Telephone Cabling
1. Attach one end of the RJ-11 telephone line
to the
Line
port. Connect the other end of
the cable into a telephone jack on the wall.
2. Attach one end of the RJ-11 telephone line
to the
Phone
port. Connect the other end of
the cable into a telephone setting.
The USB 1M HomePNA & 10/100 Fast Ethernet
is now connected to your PC. Perform the
following procedures to install the Telephone
cabling or Ethernet cabling.
Remember that if you choose to use the RJ-45
port on your USB 1M HOMEPNA & 10/100
FAST ETHERNET, the RJ-11 Phoneline
networking capabilities automatically become
disabled. The two cannot operate at the same
time.
2
If you plan to use both 10BaseT and 100Mbps network segments
on the same network, you'll need a dual-speed hub or switch that
allows segments of different speeds to communicate.