User's Manual

8
RX Buttons
Reset
Press the “RESET” button to reset the system, the system will
run through a full reset which takes approximately 5 seconds.
Input Switch
( Pending )
Press the RX unit "INPUT" button repeatedly to switch to
desired source units (TX1/ TX2…) and the “PAIRING” LED
will illuminate to indicate which source unit is being selected.
CFG (Configure)
This button is for upgrade system firmware. For further
firmware upgrade process, please refer to
Chapter 4: Software
Upgrade.
Remote Controller
Remote Controller
Stand by
The devices will be ready while this button clicking.
Switch
( Pending )
Switch the pairing input source to different 60GHz WirelessHD
Transmitters.