User's Manual

18
then on the power to complete the firmware
upgrading.
Notice :
User can upgrade the RF
firmware directly without pressing
CFG button.
Flash Program
(hex file)
1. Turn off the power supply first, and hold the CFG
(Configure) button on the device turning on the power
supply. Please remember to keep on holding the CFG
(Configure) button for two seconds. The LEDs will not
illuminate at this time.
2. Then, find and open the Host firmware file by click the
button, the browser will display to correct file path.
3. Then, select the Upload to Flash button to upgrade the
program.
4. The upgrade status will show in the column below of the
screen.
5. Wait for “upgrade success” message comes out from state
log area.
6. If get “fail” message from state log area, please re-do the
steps again
7. After finished the firmware upgrade, please turn off then
on the power to complete the firmware upgrading.
Check Host
Click this button to check the host connection status.
Set Default
Click this button to set the system back to default settings.
Cancel
Click Cancel to give up and exit the upgrade process.
Notice!
The Transmitter, Receiver and RF parts firmware cannot be
combined in one, thus user need to upgrade the firmware