User's Manual

Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user authority to operate
the equipment.
CAUTION
1. To comply with FCC RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of this
device and all persons.
2. This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
3. For product available in the USA market, only channel 1~11 can be operated.
Selection of other channels is not possible.
IMPORTANT NOTE: This module is intended for OEM integrator. The OEM
integrator is still responsible for the FCC compliance requirement of the end
product, which integrates this module. 20cm minimum distance has to be able to be
maintained between the antenna and the users for the host this module is integrated
into. Under such configuration, the FCC radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied. Any changes or
modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In
the users manual of the end product, the end user has to be informed to keep at
least 20cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio-frequency exposure
guidelines for an uncontrolled environment can be satisfied. The end user has to
also be informed that any changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is
required to be available in the users manual: This device complies with Part 15 of
FCC rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation. LABEL OF
THE END PRODUCT: The final end product must be labeled in a visible area with
the following " Contains TX FCC ID: MQ4WM2504 ". If the size of the end product is
larger than 8x10cm, then the following FCC part 15.19 statement has to also be
available on the label: This device complies with Part 15 of FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.