User's Manual

WMG2400
80 2 .11b/g Wirele ss miniPCI Card
 TX consum pt ion m ode: 630m A
 RX consum ption m ode: T350m A
Physical Specifications
 Weight : 10g
 Dim ension: 59.75 ( L) x 44.6(W) m m
Environm ent Specifications
 Oper ating Tem perat ure: 0~ 65 ℃ am bient tem perat ure
 St orage Tem perat ure: - 20~ 75
℃ am bient tem perat ure
 Oper ating hum idity: 95% m axim um ( non- condensing)
 St orage hum idity: 95% m axim um (non- condensing)
Support ed OS
 Windows 98
 Windows ME
 Windows 2000
 Windows XP
EMC Certificat ion  FCC Part 15.247 in US
Notice : The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
FCC INFORMATION
The Federal Communication Commission Radio Frequency Interference
Statement includes the following paragraph:
The equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communication. However, there is no grantee that
interference will not occur in a particular installation. If this equipment dose cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on , the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
The user should not modify or change this equipment without written approval
Form AboCom Systems, Inc. Modification could void authority to use this equipment.
Notice:
To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter 
must be installed to provide a separation distance of at least 20 cm from all persons and must not be 
co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or 
the device is permitted. Any change to the antenna or the device could result in the device exceeding the 
RF exposure requirements and void the user's authority to operate the device.