WP102 802.
FCC Certifications This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Catalog Introduction .....................................................................................................4 How to connect to the web server of AP.........................................................4 Upgrade Firmware in AP.................................................................................9 Save/Reload Settings of AP...........................................................................10 Set Account and Password for accessing web server of AP..........................
Introduction The WP102 is an IEEE802.11b compliant Access Point, which provides a powerful high-speed wireless connection for compatible wireless-enabled devices into the network with the freedom to roam. The WP102 provides 64/128 bit WEP encryption and IEEE802.1x which ensures a high level of security to protects users’ data and privacy. The MAC Address filter prevents the unauthorized MAC Addresses from accessing your Wireless LAN. Your network security is therefore double assured.
(c) Open IE and key in IP address of AP, then you can access the web server of AP and configure AP through web pages. You will see the following web page. Note: If you have changed the default IP of AP and forget current IP of AP, you can connect to the AP through COM port terminal program to get the IP. In this case, please refer to (2). (2) Get the IP of AP through COM port terminal program (a) You have to connect to the AP through COM port terminal program to get the IP.
The basic setting of the terminal program is baud rate: 38400 bps, 8-N-1, no flow control. Please refer to the following graph.
(d) Push “Enter” key , then the “#” will appear. Enter “ifconfig br0”, then push “Enter” key. You will see the IP of AP. (e) Follow the steps in (1) to connect to the server of AP.
Upgrade Firmware in AP While you get a new version of firmware of AP, you could upgrade it on web page. (1) Select the “Upgrade Firmware” web page and select a firmware image file, then push “Upload”. Wait for a while, the firmware will be updated.
Save/Reload Settings of AP You can save current settings of AP to a file or reload the settings from the file which was saved previously. Besides, you could reset the current configuration to factory default (1) Select the “Save/Reload Settings” web page.
Set Account and Password for accessing web server of AP For secure reason, you could set the account to access the web server of Access Point. Empty user name and password will disable the protection. After you have succeeded to set the account and password, next time, you will be asked to input the account/password to access the web server. (1) Select the “Password” web page and input the account/password.
(2) Input the account/password to access the web pages.