User's Manual

7
To set the operation mode to Bridge, please go to “Wireless JBasic Settings”, in
the “Mode” field click the down arrow b to select AP mode. And go to “Wireless
JWDS Settings” to enable WDS.
Note:
To act as Bridge, both AP1 and AP2 must have WDS enabled and add each
other as its WDS Access Point. (e.g. Add AP2’s MAC address to AP1’s “WDS
AP List” and vice versa)
Client Mode (Infrastructure)
If set to Client (Infrastructure) mode, this device can work like a wireless station
when it’s connected to a computer so that the computer can send packets from wired
end to wireless interface.
Refer to the illustration below. This station (AP1 plus the connected computer 1) can
associate to another Access Point (AP2), and then can have the Internet access if the other
Access Point (AP2) has the Internet connection.