User's Manual

10
CONFIGURATION
Login
1. Start your computer. Connect an Ethernet cable between your computer and the
Wireless Access Point.
2. Make sure your wired station is set to the same subnet as the Wireless Access Point, i.e.
192.168.1.254
3. Start your WEB browser. In the Address box, enter the following:
HTTP://192.168.1.254
The configuration menu is divided into four categories: Status, Wireless, TCP/IP, and
Other settings. Click on the desired setup item to expand the page in the main
navigation page. The setup pages covered in this utility are described below.
Setup Wizard
The Setup Wizard only provides brief and quick setup of this device, follow the on-screen
instuction to proceed, the Setup Wizard will guide you to complete the whole process.
1. Click Setup Wizard on the left-top side and then click Next to begin setup wizard.
2. You may change the default setting of the IP Address and Subnet Mask, click Next
to continue.