User's Manual

21
Wireless Access Control
Mode
Select the Access Control Mode from the pull-down menu.
Disable: Select to disable Wireless Access Control Mode.
Allow Listed: Only the stations shown in the table can
associate with the AP.
Deny Listed: Stations shown in the table won’t be able to
associate with the AP.
MAC Address
Enter the MAC Address of a station that is allowed to access
this Access Point.
Comment
You may enter up to 20 characters as a remark to the
previous MAC Address.
Apply Changes
Press to save the new settings on the screen.
Reset
Press to discard the data you have entered since last time
you press Apply Change.
Current Access Control
List
Click to show the current access control list.
Delete Selected
To delete clients from access to this Access Point, you may
firstly check the Select checkbox next to the MAC address
and Comments, and press Delete Selected.
Delete All
To delete all the clients from access to this Access Point,
just press Delete All without selecting the checkbox.
Reset
If you have made any selection, press Reset will clear all the
select mark.
WDS Setting
To enable WDS function will let this AP enter “Bridge Mode”. Two APs in bridge modes
can communicate with each other through wireless interface. That is, two stations associated
to different AP in bridge mode can communicate with each other.