User's Manual

Table Of Contents

Special Application

If you use Internet applications that use non-standard connections or port numbers, you may

find that they do not function correctly because they are blocked by the Wireless Router's

firewall. In this case, you can define those applications as "Special Application" so that they

can function properly.

You can define your Special Applications. You will need detailed information about the

application such as number of port required; this is normally available from the supplier of the

application.

Also, note that "Incoming" on this screen refer to traffic from the client (PC) viewpoint.

You have to firstly check Enable before you can add/edit an application.

Name

Enter the application name.

Incoming Type

Click the down arrow  to select the incoming application type (TCP

or UDP)

Incoming Port

Range

Enter one or more set(s) of port number range as the incoming ports.

Once the trigger port is detected, the incoming packets are allowed to

pass the firewall to these already specified Incoming Ports.

Trigger Type

Click the down arrow  to select the trigger type (TCP or UDP)

Trigger Start

Port

Enter a port number as the starting outbound port for the special

application defined in the preceding field.

Trigger Finish

Port

Enter a port number as the ending outbound port for the special

application defined in the preceding field.

Save

Press to save the new settings on the screen.

Undo

Press to discard the data you have entered since last time you press

Save.

WAN Port