User Manual

Chapter 4

Configuration via Web

In the setup home page, you can set your preference from Internet Port (CATV dynamic

Mode, PPPoE, Static configuration, PPTP), Local Port, Advanced Setup(Management,

Virtual Server, Packet Filter, Static Route, Dynamic DNS, URL Blocking) Network

Status (Connection Status, Session List, Users List,), and Others (Factory Reset, Save

Configuration, Firmware Upgrade. )

Internet Port

The opening screen contains settings for the Internet connection interface. Click on the

down arrow 6 to select the desired Internet connection mode on the list.

Obtain configuration automatically

(CATV dynamic mode)

For users who are using Cable Modem

Internet service.

PPPoE (DSL dynamic mode)

For users who are using xDSL Inter-

net service that runs PPPoE. If your

xDSL service uses PPPoE, after

installing the Router, do not run

PPPoE software on your computers.

Static configuration

Select this item when the ISP assigns

static IP address for your account.

PPTP (DSL dynamic mode)

CATV dynamic Mode

Selecting this mode enables you to obtain dynamic IP address from your ISP via DHCP

support. Once the IP address is obtained, you can access the Internet.

For most cases, this page needs no input. However, some ISPs may require some infor-

mation for identification purpose. For example: Device/Computer name and Domain

Name; please enter the information required to complete the settings.

Check to modify

the MAC address