User Manual

Chapter 2

Installation

Requirements

• Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.

• TCP/IP protocol must be installed on all PCs.

• For Internet Access, an Internet Access account with an ISP, and either of a DSL or

Cable modem (for WAN port usage)

• To use the Wireless Access Point, all Wireless devices must be compliant with the

IEEE802.11b or IEEE802.11g specifications.

Procedure

Figure 4: Installation Diagram

1. Choose an Installation Site

Select a suitable place on the network to install the Wireless Router.

Ensure the Wireless VPN router and the DSL/Cable modem are powered OFF.

2. Connect LAN Cables

Connect PCs to the LAN ports on the Wireless VPN router with standard LAN cables

(RJ-45).

3. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the Wireless Router. Use the cable

supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.

4. Power Up

• Power on the Cable or DSL modem.

• Connect the supplied power adapter to the Wireless VPN router and power up.

Use only the power adapter provided. Using a different one may cause hardware damage