User's Manual

12
Step 3- LAN
This step can set up local area network of the Wireless Router, such as IP address, subnet mask, DHCP
type, DHCP IP addresses range, DHCP subnet mask and DHCP lease time.
IP Address
Shows the IP address of the Wireless Router (Default IP address is
192.168.1.1.)
Subnet Mask
The subnet mask of the Wireless Router (Default subnet mask is
255.255.255.0.)
DHCP Type
Disable: Select to disable this Wireless Router to distribute IP
addresses to connected clients.
Server: Select to enable this Wireless Router to distribute IP Addresses
(DHCP Server) to connected clients. And the following field will be
activated for you to enter the starting IP Address.
Start IP Address
The starting address of this local IP network address pool. The pool is a
piece of continuous IP address segment. Keep the default value
192.168.1.100 should work for most cases.
End IP Address
The end IP address, the maximum is 254. If “Start IP Address” is set at
192.168.1.100 and the “End IP address” is 192.168.1.200, the device
will distribute IP addresses from 192.168.1.100 to 192.168.1.200 to all
the computers in the network that request IP addresses from DHCP
server (Router).
Subnet Mask
The subnet mask of the distribute IP addresses clients, the subnet mask
must be set at the same segment as the Wireless Router.
Primary DNS Server
Secondary DNS
Server
The DNS should be set to the address provided by your ISP.
Default Gateway
Enter the default gateway IP address provided by your ISP in this
column.