User's Manual

WDS

To use WDS function:

1. The APs must support WDS function.

(To set WDS must use the same wireless product (the same model will be better); due to different

wireless products might support different WDS settings. Thus, it is suggested that to use the same

wireless products that support WDS function.)

2. To set the same SSID on the APs.

3. To set the same channel on the APs.

4. To set the same Wireless MAC address on the APs.

5. To set same security (WEP or WPA) on the APs.

Wireless Distribution System (WDS)

WDS Mode

Select the mode from the pull-down menu, Disable, Lazy Mode, Bridge

Mode or Repeater Mode. (Default WDS mode is Disable.)

If the users would like to set up the WDS function, please go to Wireless>

Basic to set up APs that should use the same SSID(case-sensitive) and

Channel , then go back to Wireless> WDS to enter Wireless MAC

address of each other to make the WDS connection. (It depends on the

mode that you selected to enter the Wireless MAC address.)

Step 1: Setup the same SSID and Channel on both wireless APs.