User's Manual

15
Server: Select to enable this Wireless Router to distribute IP Addresses
(DHCP Server) to connected clients. And the following field will be
activated for you to enter the starting IP Address.
Start IP Address
The starting address of this local IP network address pool. The pool is a
piece of continuous IP address segment. Keep the default value
192.168.1.100 should work for most cases.
End IP address
The end IP address, the maximum is 254. If “Start IP Address” is set at
192.168.1.100 and the “End IP address” is 192.168.1.200, the device will
distribute IP addresses from 192.168.1.100 to 192.168.1.200 to all the
computers in the network that request IP addresses from DHCP server
(Router).
Subnet Mask
The subnet mask of the distribute IP addresses clients, the subnet mask
must be set at the same segment as the Wireless Router.
DHCP Primary
DNS Server
You can specify your own preferred DNS server IP address(es).
DHCP Secondary
DNS Server
Secondary DNS Server is optional. You can enter another DNS server’s IP
address as a backup.
Default Gateway
Shows the default gateway IP address.
Lease Time
The lease time of the distribute IP Addresses. Default settings are 86400
seconds.
Statically
Assigned
MAC: Enter the MAC address of a certain station, and then the DHCP
Server will to distribute a fixed IP address to the station automatically once
be connected.
IP: Enter the fixed IP address that DHCP Server assigned to a certain
connected station.
User can set up 3 set of fixed IP addresses that distribute form the Wireless
Router when the DHCP Type function be selected to Server.
UPNP
Universal Plug and Play (UPnP) is a set of computer protocols promulgated
by the UPnP Forum. The goals of UPnP are to allow devices to connect
seamlessly and to simplify the implementation of networks in the home
(data sharing, communications, and entertainment) and in corporate
environments for simplified installation of computer components. UPnP
achieves this by defining and publishing UPnP device control protocols
built upon open, Internet-based communication standards. The term UPnP
is derived from plug-and-play, a technology for dynamically attaching
devices directly to a computer.
Select Disable or Enable from the pull-down menu.
PPPoE Relay
Select Disable or Enable from the pull-down menu.
DNS Proxy
Select Disable or Enable from the pull-down menu.
Apply
After completing the settings on this page, click Apply button to save the
settings.
Cancel
Click Cancel to restore to default values.