User's Manual

Access Policy

Policy

Set access control policy of the stations. Select Disable, Allow or Reject form

the pull-down menu.

Add a station

Mac

Enter a station MAC in the blank field. The maximum rule count is 8.

WDS

Making a connection between access points by using WDS function, please follow below steps.

1. The APs must support WDS function.

(To set WDS must use the same wireless product (the same model will be better); due to different

wireless products might support different WDS settings. Thus, it is suggested to use the same

wireless products that support WDS function.)

2. To set the same SSID on the APs.

3. To set the same channel on the APs.

4. To set the same Wireless MAC address

(BSSID) on the APs.

5. To set same security (WEP or WPA) on the APs.

Wireless Distribution System (WDS)

WDS Mode

Select the mode from the pull-down menu, Disable, Bridge Mode or

Repeater Mode. (Default WDS mode is Disable.)

If the users would like to set up the WDS function, please go to Wireless>

Basic to set up APs that should use the same SSID(case-sensitive) and

Channel , then go back to Wireless> WDS to enter Wireless MAC

address

(BSSID) of each other to make the WDS connection.

Step 1: Setup the same SSID and Channel on wireless APs.