User's Manual

WPS Config

WPS

Select Enable then click Apply to use WPS (Wi-Fi Protected Setup)

function, then push physical WPS button on Wireless Router to make a

WPS connection. Default setting is Disable.

WPS Summary

WPS Current

Status

After enabling the WPS function, if there is connection the status will show

Configured, otherwise, the status will show Idle.

WPS Configured

Trigger WPS AP to do simple config with WPS Client. If WPS configured,

here shows Yes, otherwise, NO.

WPS SSID

Shows the Wireless Router network name.

WPS Auth Mode

The WPS authentication type supports Open, Shared, WEP Auto, WPA-

PSK, WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK. Please go to the

configuration page Wireless Settings > Security to set up the WPS security.

WPS Encryp Type

For Open authentication mode, the selection of encryption type are NONE

and WEP. For WPA-PSK, WPA2-PSK and WPA-PSK/ WPA2-PSK

authentication mode, the encryption type supports TKIP, AES and

TKIP/AES.

WPS Default Key

Index

Shows the WEP default key (1~4).

WPS Key(ASCII)

Shows the WPS security keys (ASCII). The key can be used to ensure the

security of the wireless network.

AP PIN

Here shows the AP’s PIN code (Personal Identification Number) that the

enrollee should enter the registrar’s PIN code to make a connection.

Reset OOB

Reset WPS AP to the OOB (out-of-box) configuration.

WPS Process

WPS mode

PIN: Personal Identification Number. Select PIN then click Apply to make

a WPS connection.

PBC: Push Button Communication. Select PBC then click Apply to make a

WPS connection.

PIN Number

Personal Identification Number. Input Enrollee’s Pin Code to AP-Registrar.

WPS Status

Here shows the current status of the WPS. If there is connection the status

shows WSC Success, otherwise, the status shows Idle.