User's Manual

2
Blinking
WPS is enabled to make a
connection
OFF WLAN function off
ON WLAN link / active
WLAN
WLAN
Green
Blinking WLAN traffic transmitting
ON WAN link / active
OFF WAN function off
WAN
WAN
Green
Blinking WAN traffic transmitting
OFF LAN function off
ON LAN link / active
LAN 1~4
Green
Blinking LAN traffic transmitting
Rear Panel
WPS
To enable the WPS function via web configuration (Wireless >
WPS), then press the WPS button once on the Wireless Router,
the WPS LED will start to flash. To make a connection with other
WPS supported device within 3 minutes.
RESET
Keep on pressing the Reset button more than 3 seconds, the
Wireless Router will set all setting back to factory default values.
LAN 1~4
Use standard LAN cables (RJ45 connectors) to connect your
PCs to the port. If required, any port can be connected to another
hub. Any LAN port will automatically function as an "Uplink" port
when necessary.
WAN
Connect the ADSL or Cable Modem here with RJ45 cable. If
your modem came with a cable, use the supplied cable,
otherwise, use a standard LAN cable.
POWER
Connect the power supply adapter here.