User's Manual

8
If you cannot connect...
If the Wireless Router does not respond, please check following:
• The Wireless Router is properly installed, LAN connection is OK, and it is already
powered ON. You can test the connection by using the "Ping" command:
• Please go to Start>Run…> Enter “cmd” command in the column to open
the MS-DOS window.
• Enter the command: ping 10.10.10.254
If no response is received, either the connection is not working, or your PC's IP
address is not compatible with the Wireless Router's IP Address. (See next
item.)
• If your PC is using a fixed IP address, its IP address must be within the range
10.10.10.1. to 10.10.10.253 to be compatible with the Wireless Router's default IP
Address of 10.10.10.254. Also, the Network Mask must be set to 255.255.255.0.
See Chapter 4 - PC Configuration for details on checking your PC's TCP/IP settings.
• Ensure that your PC and the Wireless Router are on the same network segment. (If
you don't have a router, this must be the case.)
• Ensure you are using the wired LAN interface. The Wireless interface can only be
used if its configuration matches your PC's wireless settings.