User's Manual

12
Address Mode: Select Static to set up the IP address that provide by your ISP
manually, or select Dynamic to obtain the IP address automatically.
IP Address: Enter the WAN IP address provided by your ISP here.
Subnet Mask: Enter the subnet mask here.
Default Gateway: Enter the default gateway IP address provided by your ISP
here.
Step 2- LAN
This step can set up Wireless Router’s IP address, subnet mask, DHCP type, DHCP IP addresses range,
DHCP subnet mask and DHCP lease time.
IP Address
Shows the IP address of the Wireless Router (Default IP address is
10.10.10.254.)
Subnet Mask
The subnet mask of the Wireless Router (Default subnet mask is
255.255.255.0.)
DHCP Type
Disable: Select to disable this Wireless Router to distribute IP addresses
to connected clients.
Server: Select to enable this Wireless Router to distribute IP Addresses
(DHCP Server) to connected clients. And the following field will be
activated for you to enter the starting IP Address.
DHCP Start IP
The starting address of this local IP network address pool. The pool is a
piece of continuous IP address segment. Keep the default value
10.10.10.100 should work for most cases.
DHCP End IP
The end IP address, the maximum is 253. Default value 253 should
work for most cases (10.10.10.253.) If “Start IP Address” is set at
10.10.10.100 and the “End IP address” is 10.10.10.253, the device will
distribute IP addresses from 10.10.10.100 to 10.10.10.253 to all the
computers in the network that request IP addresses from DHCP server
(Router).