User's Manual

24
Wireless Network
Radio On/Off
Click Radio ON/OFF button to turn on/off the radio function.
Network Mode
Select 11b/g mixed, 11b only, 11g only, or 11b/g/n mixed mode from
the pull-down menu. (Default is 11b/g/n mixed mode.)
Network Name
(SSID)
A SSID is referred to a network name because essentially it is a name
that identifies a wireless network.
Multiple SSID 1~3
A multiple SSID is referred to a network name because essentially it is a
name that identifies a wireless network.
Broadcast Network
Name(SSID)
Enable
: This wireless AP will broadcast its SSID to stations.
Disable
: This wireless AP will not broadcast its SSID to stations. If
stations want to connect to this wireless AP, this AP’s SSID should be
known in advance to make a connection.
AP Isolation
Select Enable or Disable to enable this function.
Access Point Isolation, this function is used to separate wireless clients
to access each other while connected to the same access point.
MBSSID AP
Isolation
Select Enable or Disable to enable this function.
When this function be enabled, clients connected to different network
name(SSID) access points cannot access to each other, but can access to
the clients that under connecting to the same SSID AP.
BSSID
Shows the Wireless MAC address of the Wireless Router.
Frequency (Channel)
Select 1~13 or Auto Select from the pull-down menu.
HT Physical Mode
Operating Mode
Green Field (11n mode), Mixed Mode(11b/g/n mode). Select Mixed
Mode or Green Field. (Default operating mode is Mixed Mode.)
Channel Band Width
Select 20 or 20/40. (Default setting is 20/40.)
Guard Interval
Select Long or Auto. (Default setting is Auto.)
MCS
Default setting is Auto.
Reverse Direction
Grant(RDG)
Select Disable or Enable this function. (Default setting is Enable.)
Extension Channel
According the Frequency (Channel) that you selected, here will show
the Extension Channel(s).
Aggregation MSDU
(A-MSDU)
Select Disable or Enable. (Default setting is Disable.)
Auto Block ACK
Select Disable or Enable. (Default setting is Enable.)
Decline BA Request
Select Disable or Enable. (Default setting is Disable.)