User's Manual

To use WDS function:

1. The APs must support WDS function.

(To set WDS must use the same wireless products (the same model will be better); due to

different wireless products might support different WDS settings. Thus, it is suggested that to use

the same wireless products that support WDS function.)

2. To set the same SSID on the APs.

3. To set the same channel on the APs.

4. To set the same Wireless MAC address

(BSSID) on the APs.

5. To set same security (WEP or WPA) on the APs.

Wireless Distribution System (WDS)

WDS Mode

Select the mode from the pull-down menu, Disable, Lazy Mode, Bridge

Mode or Repeater Mode. (Default WDS mode is Disable.)

If the users would like to set up the WDS function, please go to Wireless

Settings> Basic to set up APs that should use the same SSID and Channel ,

then go back to Wireless settings> WDS to enter Wireless MAC

(BSSID)

of each other to make the WDS connection.

Step 1: Setup the same SSID and Channel on wireless APs.

Step 2: Enter Wireless MAC (BSSID) address to each other.

(According to the WDS mode that user selected, for example, Lazy

mode is unnecessary to enter another AP’s MAC address.)